frame off restoration project.frame sand blasted and repainted black.body of car was bead blasted and put in etching primer all molding holes were filled and car was sanded down again and put back into etching primer.this car had no rust any where.car was sprayed inside with sound deaden er.some holes filled in the dash.car has a new mustang 2 front suspension from chaise engineering.motor is a Chevy 350 with all new parts on it.turbo 350 trans.new radiator with trans cooler built in.new stainless brake lines.lots of new parts to complete car such as new .new wire harness,,new lokar emergency brake cable and handle,new lokar peddles,new center line wheels with new low profile tires,new halogen lights for front and rear ,new re chrome grill with trim,new chrome bumpers,original seats redone.way over $20k invested not including any of my time.i got the car out from the shop they did a lot of work from setting up the motor to run,set up new gas peddle and linkage. install the new brake master cylinder and lines,connected trans cooler lines,install battery in trunk,install tilt column w/billet banjo steering wheel.installed a electric fan on radiator.in stalled gas tank with new 12 volt sending unit wiring harness finished.installed sound deaden er heat shield foam to all interior floors and roof and firewall. WHAT THE CAR NEEDS. car needs exhaust installed still.car needs headliner and carpet .car needs glass to be completed.
DISCLAIMER: The information in this ad is provided by the seller and not OldRide.com. The prices, terms, and reliability of the item remains subject to the direct negotiation between the buyer and seller. OldRide.com is not responsible for any damages that may occur during a transaction. For more resources about purchasing a vehicle online visit our help section "Buying a