Engine not running, 0 compression in no 3 cylinder, rusted through ceiling, some rust on door corners, and in truck of bed
Rebuilt 283 engine with 11,000 miles, bored .30 over grant piston rings, new camshaft, cast cut crank, crank main cut at .20, crank rod cut at .10, high volume melling oil pump, melling timing gear,melling crankshaft gear, melling timing chain, and new fuel pump).
New carburetor, new performance clutch less than 600 miles on it, brand new tires, new master cylinder(brakes), new shoes(brakes), spin on oil filter adapter, new u joints and support bearing, new bushings ball joint and tie rods all the way around. Rear end is from a 65 with a 12 bolt rear end which has 31 splines instead of 17 which makes rear much stronger. Gear ratio- 3.73 non posi, manual transmission with 3 on the tree.
Runs like a champ, some rust issues but other than that is a solid project truck or rat rod
any questions message me thanks
DISCLAIMER: The information in this ad is provided by the seller and not OldRide.com. The prices, terms, and reliability of the item remains subject to the direct negotiation between the buyer and seller. OldRide.com is not responsible for any damages that may occur during a transaction. For more resources about purchasing a vehicle online visit our help section "Buying a
Vehicle".
