14 years ago in BUICK
The brake light works but it will not come on on til the brake is pushed to the floor. The brakes work fine, but I have no brake lights when I JUST PUSH A LITTLE ON THE BRAKES. How can I adjust it so the light will work as soon as I push on the brakes? Also where is the master cylinder located so I can check the fluid level?
Answers (2)
brake lite switch is on the left side by firewall and frame. The switch can be purchased at almost any parts house mine cost $9.95 at local store these a very low pressure switch, my brake lites were intermittent replaced switch and everything is OK
'55 Buick - cool car! If brakes really go to the floor - fix 'em!! Now sounds like a good time for a thorough brake system inspection - not after your accident. Master is low on dr's side firewall, almost under the floor. Find the fill pipe and remove cap to add fluid. Switch is a round 2 pin on m/cyl. It's pressure activated and there is no adjustment. If the brake system is in good contion, then replacing it should address your brake light concern. See NAPA.